Ratermann Manufacturing, Inc. Customer Service 1-800-264-7793 y Fax 1-800-264-7797 y Order Online at Web Store www.rmiorder.com 7A-34 LABEL ADHESIVE REMOVER, ABRASIVE PADS & GLOVES 100% Organic Label Adhesive Remover Industrial Formula/Citrus Solvent DO NOT DILUTE – USE FULL STRENGTH, RINSE WITH MILD SOAP & WATER. CHECK FOR COMPATIBILITY PRIOR TO USE. General Use (hard surfaces) Can be used in any industrial cleaning system including: ultrasonic cleaners, dip tanks, parts washers, and hand wiping. No special equipment or protective clothing is required for handling or disposal. Recovery: Note: This product is re-usable wherever recovery is possible. When collected in a sump or container, contaminants and water will settle out, leaving product to be poured or pumped off the top. In a bulk cleaning system, recovery for re-use should exceed 90% by volume. Parts Washers, Sonic Cleaners and Dip Tanks: Allow the parts that need to be cleaned to soak in this product or flush this product over the parts for a few minutes. Remove and allow to dry. Drying can be accelerated, if required, by wiping or blowing dry. Flash Point 162˚ F (71˚ C) Shop/Production Floors: Apply this product to the floor and allow 30 seconds to a minute, to work. Spread this product from one place to another with a squeegee. Once the area has been cleaned, this product and residue can be collected with a wet-dry vacuum cleaner, washed into a sump drain or picked up with an oil absorbent material. Tar & Asphalt Removal: Spray this product on to the affected area. In order to loosen the top skin of tar or asphalt, gently work product in with a clean cloth for spot removal, or a brush for heavily contaminated areas. Adhesives & Sealant Residue: This product is suitable for use on hot melt machines, labeling machines and work areas where adhesives and some sealants are used. Spray or wipe on this product. Allow this product to penetrate the residue. Where tape is to be removed, peel back the carrier after soaking for a couple of minutes (double-sided tape may take longer), and wipe with a clean cloth. Manufacturer is not liable for any consequential or incidental damages that result from the misapplication or misuse of this product. Sole reimbursement shall be the fund of the cost of product upon proof of purchase. Removes Heavy Duty Jobs such as • Oil, Tar, Grease, Adhesives, Caulk, Carbon Black, Wet Oil-Based Paints & Stains and More Use on • Skin, Hair, Washable Fabric, and More Biodegradable, 100% Organic, Non-Toxic No Residual After Surface Dries We have this available in • 1 quart size with trigger spray • 1 gallon container • 5 gallon sized containers Pt # LR-ACS-1GAL Pt # LR-ACS-5GAL Pt # LR-ACS-1QT Abrasive Pads Use with Label Adhesive Remover Great for Stainless Steel Adhesive Removal. Pt # ABR-PAD Gloves Use with Label Adhesive Remover to Keep Removed Adhesive Off Your Hands Abrasive pads for cleaning off adhesive when using Ratermann Label Adhesive Remover. Pt # GLOVES OUTSTANDING RESULTS FOR REMOVING CYLINDER LABEL ADHESIVES! Label Adhesive Remover Part # Description LR-ACS-1QT 1 Quart with trigger spray LR-ACS-1GAL 1 Gallon LR-ACS-5GAL 5 Gallon
