Ratermann Manufacturing, Inc. Customer Service 1-800-264-7793 y Email [email protected] y Order Online at Web Store www.rmiorder.com 21D-79 TOOLS WARNING: Products in this catalog can expose you to chemicals including Lead which is known to the State of California to cause cancer, birth defects or reproductive harm. For more information, go to https://www.p65warnings.ca.gov Tools DIG & DTM | Pre-Swaging Units This no-go gap gauge is useful tool to inspect the DK-Lok initially pulled-up. Operation Instructions On initial assembly, apply DK-Lok no-go gap inspection gauge to make sure that the make-up distance is ciently pulled-up. Refer to Fig 1. 1. The gap gauge does not the gap between the nut and the body hex. This ensures that the is ciently tightened on initial assembly. Refer to Fig 2. 2. The gap gauge the gap between the nut and the body hex. The requires an additional tightening. Operation Instruction 1. Insert tubing into DTM untilit is bottomed on tool. 2. Mark the tube at the top of the DTM with a pen. 3. Remove the tube from the DTM and insert into DK-Lok untilit is bottomed on the shoulder of the body. 4. If the marking can be seen above the nut, it indicates the tube not fully bottomed inside the Fractional Part No. Tube O.D. (in.) DK-DTM-4-C 1/4 DK-DTM-6-C 3/8 DK-DTM-8-C 1/2 DK-DTM-10-C 5/8 DK-DTM-12-C 3/4 DK-DTM-16-C 1 Metric Part No. Tube O.D.(mm) TM-6M-C 6 TM-8M-C 8 TM-10M-C 10 TM-12M-C 12 TM-16M-C 16 TM-25M-C 25 Part No Fitting Size m m ni DK-DIG-46812 This gauge works on eight sizes 1/4, 3/8, 1/2, and 3/4. 6, 10, 12, and 18 / 5 5- G I DK-D 1 - 6 DK-DIG-1 - 4 / 3 2 DK-DIG-16 1 25 Marking on tubing prior to make-up with DK-Lok. Hydraulic Swaging Unit DHS-2A Electric Swaging Unit DES-1A Pre-swaging DK-Lok ferrules onto tubing. in. 1/2, 5/8, 3/4, 1, 1 1/4, 1 1/2, and 2. mm 12, 14, 15, 16, 18, 20, 22, 25, 28, 30, 32, 38, 42 and 50. Pre-swaging unit must be used to install 1 1/4, 1 1/2, and 2 in. and 28, 30, 32, and 38 mm Contact DK-Lok authorized distributor for operating manuals of DHA-2A and DES-1A DK-D DK-D DK-D DK-D DK-D DK-D Tube Fittings All dimensions are in millimeters unless specified and only for reference subject to change. 1-800-264-7793 | DIG Gap Gauge | Pre-Swaging Units | DTM Tube Depth Marking Tool
